4 Easy Steps on How to Fix a Leaky Air Compressor Hose?


Air compressor is a great thing for modern works. This is a particular machine that can help you in many ways. The machine is so useful and easy to use that you can use for both home and professional projects. The whole system is not cheap at all.

No matter how good your air compressor is, it can always show some issues. The most common issue for an air compressor is, there is a leakage and the compressor is not working properly. Different parts of the compressor can cause leakage. You need to identify the exact location and the exact part that causing the leakage.

Among different causes of leaking, hose leakage is common. In this article, I am going to share the details on how you can fix a leaky air compressor hose easily.

Step by Step to Fix broken Air Compressor Hose

Here I am going to share the whole process step by step so that it becomes easy for you.

Step 1: Find Out the Leaking Area


If you are trying to fix the hose leakage, you need to find out where is the joining between the hose ends. This is because you will start the repairing process from there. However, if you think the leakage is happening somewhere else, you may need to replace the entire hose. But in most cases, this happens in the joint.

Step 2: Cut the Joining Between Two Ends

Once you have found the joining area of two ends of the hose, now it is time to cut down the joining for fixing it with new parts. At this point, make sure that you are using something very sharp that can easily cut the hose.

If the hose is too thick, use a professional saw for cutting it. Otherwise, a regular knife or kit is enough for cutting. Don’t cut any extension of the hose to avoid further issues. A clear and nice cut will help to complete the other tasks for fixing the leakage.

Step 3: Replace the Old Kit

Once you have cut the joining, remove the old kit from the hose. Unpack the new kit and check if all is ok there. Now remove the small part from the kit and place the larger part inside the hose. It should fit properly to the hose width.

Once you are sure that you have placed the kit in the right place, now it is time to tighten it up. With the hose kit, you will get clamps that will tighten up the hose with the kit. Use a screwdriver for tightening. Move the screwdriver gently so that it fits smoothly and securely.

For the additional security, apply some heat on the plastic hose. This will fit more tightly the kit with the hose. Heating the hose doesn’t require anything heavy. You may apply the heat simply with a lighter.

Repeat the same process for another end of the hose. Once it is done, now place the small kit in the place with the larger part. You will see that it is sitting very tightly with the larger part.

Once this process is done, now connect two ends of the hose with the kit. It will stay secure and prevent leakage. If you want more safety, go to the next step.

Step 4: Use A Plastic Bag Additionally

For a more secure connection between two ends of the hose, you can apply a plastic bag on the hose. Basically, you have to wrap the bag over the hose for making a slope. Do it only for the center.

After wrapping the plastic bag tightly, use some electrical tape to place the plastic on the place. Start from one side and wrap the tape over the bag.

Repair Leaking Air Compressor Hose

Final Words

If you have followed all the above steps, you have fixed the leakage of the air compressor hose. Now it is time to check the connection if it is working perfectly. Start your air compressor and check the joining to ensure it is not leaking anymore.

Keep in mind that you must use the best quality kit for fixing the hose. It may cost you some extra but you will get the best performance. However, if there is more than one leakage, it is recommended to replace the whole hose. Take some expert help if you find difficulties in any of the above steps.

Leave a Comment